Does this machine have its iLO license? If so, you’re in for a treat, if you’ve never used IPMI or similar out-of-band server management. Starting as a glorified KVM, it then has full power control authority (power on/off, soft reset, hard reset), either a separate or shared Ethernet connection, virtual CD and USB, SNMP reporting, and other whiz-bang features. Used correctly, you might never have to physically touch the machine after installation, except for parts replacement.
What is your go-to place to source drive caddies or additional bays if needed?
When my Dell m1000e was missing two caddies, I thought about buying a few spares on eBay. But ultimately, I just 3d printed a few and that worked fine.
Finally, server racks are absurdly expensive of course. Any suggestions on DIY’s for a rack would be appreciated.
I built my rack using rails from Penn-Elcom, as I had a very narrow space I wanted to fit my machines. Building an open-frame 4-post rack is almost like putting a Lego set together, but you will have to take care to make sure it doesn’t become a parallelogram. That is, don’t impart a sideways load.
Above all, resist the urge to get by with a two-post rack. This will almost certainly end in misery, considering that enterprise servers are not lightweight.
Congrats on the acquisition!
Does this machine have its iLO license? If so, you’re in for a treat, if you’ve never used IPMI or similar out-of-band server management. Starting as a glorified KVM, it then has full power control authority (power on/off, soft reset, hard reset), either a separate or shared Ethernet connection, virtual CD and USB, SNMP reporting, and other whiz-bang features. Used correctly, you might never have to physically touch the machine after installation, except for parts replacement.
When my Dell m1000e was missing two caddies, I thought about buying a few spares on eBay. But ultimately, I just 3d printed a few and that worked fine.
I built my rack using rails from Penn-Elcom, as I had a very narrow space I wanted to fit my machines. Building an open-frame 4-post rack is almost like putting a Lego set together, but you will have to take care to make sure it doesn’t become a parallelogram. That is, don’t impart a sideways load.
Above all, resist the urge to get by with a two-post rack. This will almost certainly end in misery, considering that enterprise servers are not lightweight.