I’m not an expert, so grain of salt and whatnot.

You can designate drives in the zfs array as cache disks. I have spinning disks setup as raid-z and an SSD as the cache then just dump everything to the array and let sw figure out what to do with it

Ok, so maybe I was mistaken, maybe it’s using the already established session you have open, or maybe it takes a restart for that setting to take effect. It’s hard to tell from one gif. I remembered it not working when I had that unchecked.

Good job being a complete shitheel about it though. And you wonder why people think you’re a troll and/or shill?

Some basic options for networking can be set on this page. For most users, it is recommended to enable the “Allow remote access to this server” option

Not needed if this is a local only server. default configuration guide…

Yes it is if you want to use it from any other computer on your lan.